3D Resin Printing - summary of the last batch

Having written my half year review I wondered how much I had actually printed. So here is a summary

• 5 x M3A1 Stuarts - for my British desert forces
• 1 x M3 Lee - a test for replacing my diecasts
• 1 x Gaz bus for my Russian Command
• 2 x Jagdpanthers - to match my single Matchbox model
• 1 x 28mm stagecoach - for Wild West games
• 7 x 28mm mounted Mexicans plus spare horses
• 3 x Japanese Ka-Mi tank hulls - to replace some that exploded (*)
• 3 x Japanese I-Go tank hulls - to replace some that exploded (*)
• 6 x softskins for a friend
• 16 x Spanish Round Hat Infantry - to use as French Legion Nautique in Egypt with a few left overs from before
• 24 x Russian Pavlov Grenadiers
• 450 x Russian Infantry - Mixed Grenadiers/Musketeers/Jaegers

Overall a very sucessful run with a low level of failures and only one FEP failure. Elegoo water washable ABS resin used throughout.

* These were printed after I discovered the problems with uncured resin remaining in the model voids, but I had not added large enough drain holes