23/08/2021

My new toy

An Elegoo Saturn 3D Resin printer arived today
Only just finished setting it up and installing the software, so it will still be a while before I start testing some output.

3 comments:

Trebian said...

Shall be interested to see how this goes for you. I'm still not sold on them as I don't understand them! Interested in cost per unit and time to produce. I can't see printing a 200 figure army with one of these when Strelets are so cheap.

CPN said...

Hello Will,
Very exciting. I will monitor closely your progress as I am also on the edge for buying one.
Enjoy the experience!
CPN

Chris Kemp said...

From the prints that I have had, resin would be the way to go. Toxicity is still an issue but I'm sure you are aware of that and have taken appropriate precautions with ventilation.

Regards, Chris.