Upgrading my Napoleonic Austrian Limbers

The only source of a decent Austrian Limber in 20mm is in the Austrian Cavalry Artillery set, which is virtually unobtainable at sensible prices, so when I found an STL file for $3.50 I had to get it and print off as many as needed to replace my old Airfix limbers, so here is the result after rebasing as well.

The limber is not perfect as the gun pivot is over the centre of the axle and as a result the ammunition box is too far forward, but it was close enough for my purposes and better than what I had been using.

I did attempt to adjust the file using 3D builder, but the task was beyond the capabilities of my PC.